1 / 8
A wall bracket and a ring clamp for a flagpole, made to hold under constant wind: two halves on screws, stiffening ribs.
We reply within 24 h. Send photos and sizes – we tell you for free if it can be done.
The flagpole mount had to withstand strong, constant wind without loosening. The old parts did not keep the joint rigid enough.
A mounting set for a flagpole: the wall bracket clamps the tube with two halves and screws, and the ring clamp holds the pole higher up. The main job of the design is to hold the flagpole securely and keep the joint rigid under constant wind loads.
Stiffening ribs and hex pockets for the nuts keep the screws from working loose over time. We make it from the old part or from measurements, for your tube diameter.
| Type | Bracket and clamp for holding a flagpole |
|---|---|
| Purpose | Holds the pole firmly and keeps the joint rigid under constant wind |
| Design | Two halves clamped with screws, stiffening ribs, hex pockets for nuts |
| Mounting | On a wall or a post; ring clamp for the tube |
| How we make it | From the original part or from measurements |
NewWe designed and printed a mini skirting that hides parts of the door construction. The clip is shaped for the aluminium profile: press it on until it clicks – no glue, no screws. The design follows the profile shape and the right press fit.
NewWe made the double gear for the slicing mechanism of a bread and food slicer: rebuilt the geometry of the original, created a 3D model and printed the replacement.
NewFitted in front of the front wheel, it guides the airflow and keeps off spray and dirt. We rebuilt the damaged part with 3D modelling and 3D printing.
NewWe made the front parking sensor bracket: a 3D scan of the original part, a prepared model and a new print that matches the mounting dimensions.
We contact you within 2 working hours to confirm price and timing.
See the order in your account Back to the catalogWe check for free whether the part can be made and come back with a proposal.
