NewBody & lights
Geely Coolray (SX11) – right bumper grille
We rebuilt the right front bumper grille by the fog light: a 3D scan, model clean-up and a new 3D-printed part.
1
1 / 4
Car interior
Mercedes-Benz W123 – inner door handle insert
Inner door handle insert for the Mercedes-Benz W123, modelled from a scan of the part and the chrome frame. It fits the original frame – the door opens comfortably from inside again.
Specifications
| Compatible with | Mercedes-Benz W123 |
|---|---|
| What it does | Inner door handle insert – fits the original chrome frame |
| How it is made | 3D scan of the insert and frame, CAD modelling, 3D printed |
| Reorder | Kept on file – a copy can be ordered without new modelling |
What we did
- 3D scanning
- CAD reconstruction
- Final part
- For
- Mercedes-Benz W123
- Category
- Automotive
The 3D model is ready to print
We modelled this part from scratch from the customer’s sample. The model stays with us, so a copy can be printed at any time – without the modelling stage, which makes it faster and cheaper than a new job. If needed, we adapt the dimensions or the material.
Order a copy →We reply within 24 h. Send photos and sizes – we tell you for free if it can be done.
How we did it
-
3D scanning
We scanned both parts: the damaged insert and the chrome handle frame.
-
CAD / reverse engineering
We modelled the insert in two ways. The frame gave the most information about the exact geometry and fit.
Similar projects
All projects →New
NewBody & lights
Geely Coolray (SX11) – parking sensor bracket
We made the front parking sensor bracket: a 3D scan of the original part, a prepared model and a new print that matches the mounting dimensions.
0
NewBody & lights
Lexus RX / Toyota Harrier – front air deflector
Fitted in front of the front wheel, it guides the airflow and keeps off spray and dirt. We rebuilt the damaged part with 3D modelling and 3D printing.
0
NewCameras & car electronics
Renault – Extended Grip unit housing (CAN bus)
A new housing (V2) for the Extended Grip unit on a Renault, connected to the CAN bus. It follows the original wiring, so the install looks neat.
8
