NewBody & lights
Geely Coolray (SX11) – parking sensor bracket
We made the front parking sensor bracket: a 3D scan of the original part, a prepared model and a new print that matches the mounting dimensions.
0
1 / 4
Body & lights
Chevrolet Camaro – front bumper trim
Front bumper trim for the Chevrolet Camaro, recreated from a 3D scan. It forms the sporty front contour and mounts on the factory fixing points.
Specifications
| Compatible with | Chevrolet Camaro |
|---|---|
| What it does | Front bumper trim – forms the sporty front contour |
| Features | Factory mounts rebuilt and reinforced; made in two halves for strength |
| How it is made | 3D scanning, CAD, 3D printing, filler, primer and paint |
| Reorder | Kept on file – a copy can be ordered without new modelling |
What we did
- 3D scanning
- CAD reconstruction
- Final part
- For
- Chevrolet Camaro
- Category
- Automotive
The 3D model is ready to print
We modelled this part from scratch from the customer’s sample. The model stays with us, so a copy can be printed at any time – without the modelling stage, which makes it faster and cheaper than a new job. If needed, we adapt the dimensions or the material.
Order a copy →We reply within 24 h. Send photos and sizes – we tell you for free if it can be done.
How we did it
-
3D scanning
We captured the geometry with a professional 3D scanner and cleaned the point cloud.
-
CAD / reverse engineering
We aligned and smoothed the surface and rebuilt and reinforced the factory mounts.
-
Final printed part
The model was split in two halves for strength and print quality. Then filler, primer and paint.
What we changed and improved
The factory mounts are stronger than the original.
Similar projects
All projects →New
NewBody & lights
Lexus RX / Toyota Harrier – front air deflector
Fitted in front of the front wheel, it guides the airflow and keeps off spray and dirt. We rebuilt the damaged part with 3D modelling and 3D printing.
0
NewBody & lights
Geely Coolray (SX11) – right bumper grille
We rebuilt the right front bumper grille by the fog light: a 3D scan, model clean-up and a new 3D-printed part.
1
NewCameras & car electronics
Renault – Extended Grip unit housing (CAN bus)
A new housing (V2) for the Extended Grip unit on a Renault, connected to the CAN bus. It follows the original wiring, so the install looks neat.
8
